Next Return Previous

Crescent Tool Cable Puller
(#3753)

 

Front Rear
Front Rear

Technical Details

Rick Banning gave me this one in 1992.

My Crescent Tool Cable Puller is 94 mm. long, 172 mm. wide, 36 mm. high, and weighs 776 g. It is made from steel forgings.

The front side of the arm has "383 CRESCENT TOOL CO. JAMESTOWN N.Y." in raised letters. The rear side of the arm has "MADE IN THE UNITED STATES OF AMERICA" and "PAT. NO 1942625." The rear of the body has the following, also in raised letters:

383
CAPACITY
4MM 8MM
5/32 TO 5/16 IN
2200 KGS                
5000 LBS    SAFE LOAD

Comments

Bob Thrun mentioned cable pullers in the mechanical ascender chapter of Prusiking, wondering if someone might make a lightweight version for caving use. This is the same model tool as I used to use for stretching fence on the farm. It grips well on wire, but is too heavy for caving.

For far more content, use a larger monitor and a full-width window.

Hundreds of cell phone users complained and asked me to for a simpler, mobile friendly site. In particular, they wanted me to limit each page to a small number of pictures and minimize my use of text. This new site provides what they asked for.